Uploading WSDL doesn't generate pattern

Submitted by danielaldana on Fri, 01/13/2012 - 21:46

Hi,

I'm trying to upload a ASMX WSDL but somehow it just doesn't generate the pattern necessary to configure the service call in the controller rules. Normally, this would be generated automatically but for this specific WSDL it doesn't do it. Attached are some screenshots of what I'm trying to do and the resulting controller rule.

Thanks for your help![hr][/hr]
Forgot to upload the WSDL file I'm trying to upload.

Attachment

Step1.jpg

Step2.jpg

Step3.jpg

Step4.jpg

Service.wsdl

RE: Uploading WSDL doesn't generate pattern

Hi,

I'm trying to upload a ASMX WSDL but somehow it just doesn't generate the pattern necessary to configure the service call in the controller rules. Normally, this would be generated automatically but for this specific WSDL it doesn't do it. Attached are some screenshots of what I'm trying to do and the resulting controller rule.

Thanks for your help![hr][/hr]
Forgot to upload the WSDL file I'm trying to upload.

Hi,
There does no look to be any obvious problem with the WSDL you attached. However, it is a Soap 1.1 & 1.2 WSDL. Could you check the patch version of the Design Studio?
Please look in the following directory to establish which patches are installed: C:\jprogramfiles\hyfinity\runtime\licences\patches OR
C:\Program Files\BizFlow\WebMaker\runtime\licences\patches

Patches are required up to and including Patch MVC_3.1.2.0003 as a minimum.

RE: Uploading WSDL doesn't generate pattern

I've been updating with BizFlow Process Studio and only had the MVC_3.1.2.0006 and MVC_3.1.2.0007 patches. I installed the MVC_3.1.2.0003 patch and it worked! Thanks!

RE: Uploading WSDL doesn't generate pattern

I've been updating with BizFlow Process Studio and only had the MVC_3.1.2.0006 and MVC_3.1.2.0007 patches. I installed the MVC_3.1.2.0003 patch and it worked! Thanks!

OK, that is good, and not so good.
It is very important that all patches are installed in order. If BizFlow Process Studio upgrade is not doing this automatically, then you will need to manually install Patches 1 to 7 again, in the correct order to ensure everything is OK.